Tesla Model X: Antenna Amplifier - AM/FM and RKE (Remove and Replace)

Removal

1. Remove the LH liftgate side trim (refer to procedure).
2. Remove the screw that secures the antenna amplifier to the liftgate (torque 8 Nm).

    

3. Disconnect both electrical connectors from the antenna amplifier.

    

4. Release the clip that secures the antenna amplifier to the liftgate.
5. Carefully release the antenna amplifier lead from the glass connectors (x2).

    

6. Release the adhesive strip that secures the antenna amplifier to the liftgate glazing.
7. Remove the antenna amplifier from the vehicle.

Installation procedure is the reverse of removal, except for the following:

Note: Clean the affected areas before installation.

Caution: Apply contact adhesive to the mating faces if the bond has been broken.

1. Replace the adhesive strip if necessary.
2. Ensure all contacts are clean and bond to the surface mounted antenna.

Note: Listen for an audible click when connecting harness connectors.

Antenna Amplifier - FM2 (Remove and Replace)

1. Remove the RH liftgate side trim (refer to procedure).
2. Disconnect the electrical connector from the antenna amplifier.
3. Carefully release the antenna lead from the liftgate glass.
4. Remove the screw that secures the antenna amplifier to the liftgate (torque 8 Nm).
5. Remove the antenna amplifier.

Installation procedure is the reverse of removal.

Antenna - Satellite Radio (Remove and Replace)

1. Remove the headliner (refer to procedure).
2. Remove the center spine applique (refer to procedure).
3. Disconnect the electrical connector for the antenna.
4. Carefully release the antenna from the adhesive that secures it to the body.
5. Pull the antenna harness out through the hole in the top of the body. Remove the antenna from the vehicle.

Caution: Ensure that the harness does not catch on other connectors during removal.

Installation procedure is the reverse of removal, except for the following:

• Use alcohol and a razor blade to remove all remaining adhesive.
• Apply adhesion promoter before securing the new antenna.
• After connecting the antenna harness, verify normal satellite radio operation.