Tesla Model X: Brake Caliper - Rear - Park Brake - LH (Remove and Replace)

Note: If the event of a stuck caliper or motor failure, refer to one of these procedures to release the caliper:

• Rear Park Brake Caliper - Caliper Seized/Motor Failure - Release Caution: This method requires replacing the caliper after it has been released.
• Park Brake Caliper - Release - Harness Tool - Through Calipers
• Park Brake Caliper - Release - Harness Tool - Through ECU

1. Remove the brake pads from the caliper (refer to procedure).
2. Disconnect the electric parking brake caliper harness connector.

   

3. Remove and discard the bolts (x2) that secure the caliper to the knuckle (torque 57 Nm).

   

4. Remove the parking brake caliper.

Installation procedure is the reverse of removal, except for the following:

• Clean the affected areas before installation.