Tesla Model X: Latch - Hood (Remove and Replace)
Removal
- Remove the front underhood apron (refer to procedure).
- Release both hood latch cables (x2) from the latch assembly.
- Disconnect the harness connector from the LH side of the latch
assembly.
- Remove the bolts (x2) that secure the latch to the front end
module (FEM) (torque 10 Nm).
- Remove the latch assembly from the vehicle.
Installation
Installation procedure is the reverse of removal, except for the
following:
- Apply approximately 0.1 grams of RheoGel TEK676 grease to
both of the areas shown.
Front latch |
Rear latch |
|
|