Tesla Model X: Brake Pads - Front - Set (Remove and Replace)
Warning: If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.
Special tool required for this procedure:
Supplier | Part Number | Description |
Tesla | 1057223-00-A | Hand Brush |
- Remove the front wheels (refer to procedure).
- Remove the pad retaining pins and collect the anti-rattle
spring.
Note: Always check that the anti-rattle clip has not been damaged. This part is easily damaged and is important to help eliminate squeaks.
- Use a suitable tool to gently push the pistons back into the caliper.
- Remove the brake pads from the caliper.
- Check that the caliper pad slides are dirt free and the seals are in good condition.
- Repeat steps 2-5 on the other side of the vehicle.
Installation procedure is the reverse of removal, except for the following:
Note: Clean the affected areas before installation.
- Thoroughly clean the caliper pad slides and abutments with a
hand brush (1057223-00-A) and soapy water.
Caution: If there is rust or pitting on the caliper that
cannot be removed with a hand brush, replace the caliper
(refer to procedure).
- Apply an even layer of Silaramic lubricant (1063021-00-A) to the caliper pad slides. Remove any excess lubricant.
- Apply an even layer of copper paste between the shim and the
backing plate. Remove any paste that squeezes out after
installing the shim.
Caution: Ensure that the brake pads move freely.
Caution: Do not apply copper paste to the caliper, seals, or any component other than the shim and backing plate.
- Pump the brake pedal at least 5 times to seat the pads against the brake rotors.
Warning: Always check that the brake pads are seated correctly before driving the vehicle.
- Top off the brake fluid level as required.
Caution: If brake fluid is spilled on a painted surface, wash off immediately with clean water.
- Perform the burnishing procedure (refer to procedure).