Tesla Model X: HV Battery Coolant - Refill

  Caution: Only fill the battery with the specified coolant. In this manual, refer to General Information > Fluids and Capacities > Fluids.

1. Fill the battery coolant fill tool with the specified coolant.
2. Connect the coolant service fixture to one of the hoses on the fill tool.
3. Position the other hose on the coolant service fixture to drain into a bucket or other appropriate used coolant receptacle.
4. Ensure that the switch on the fill tool is set to "Dispense".

   

5. Open the fill valve on the fill tool.

   

6. Pump the hand pump to fill the battery with the specified coolant.

Note: The fill tool has a pressure regulator to prevent the battery from being overpressurized.

Note: Watch the coolant level in the fill tool. If the coolant level drops too low, the fill tool pumps air into the battery and the procedure has to be repeated.

7. When the battery is nearly full, the coolant starts to rise in the drain hose. Close the fill valve when the coolant exiting the battery is mostly free of air bubbles.

Note: The coolant exiting the battery does not need to be completely free of air bubbles.

8. Open the relief valve on the fill tool.

   

9. Remove the coolant service fixture from the HV battery.

Tip: The 2 hoses on the coolant service fixture can be connected to each other for easier handling and storage.