Tesla Model X: Lamp - Side Repeater - Front - LH (Remove and Replace)

Tesla Model X 2015-2024 Service Manual / Electrical / Lamp - Side Repeater - Front - LH (Remove and Replace)

Remove

Remove the front LH wheel (refer to procedure).
Release the rearmost push clips (x7) that secure the wheel arch liner.
Remove the rear nut that secures the wheel arch liner to the stud on the chassis (torque 6 Nm).
Move the rear portion of the wheel arch liner for access to the side repeater lamp.
Remove the NVH pad for access to the side repeater lamp.
Disconnect the electrical connector from the side repeater lamp.
Release the locking tabs that secure the side repeater lamp to the fender. Tip: If the lamp is not going to be reused, break the lower locking tab to make the lamp easier to remove.
Remove the side repeater lamp from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following: Ensure that the side repeater lamp is flush with the fender.

SEE MORE:

Trim - C-Pillar - Mid - LH (Remove and Replace)

Remove Remove the lower C-Pillar trim panel (refer to procedure). Remove the rear trunk side trim panel (refer to procedure). Release the 2 screws that secure the trim panel (torque 3 Nm). Release the 4 trim clip

Underhood Apron - LH (Remove and Replace)

Remove Remove the rear center underhood apron (refer to procedure). Gently pull up on the LH apron to release the clips that secure it to the vehicle.Caution: Take care not to damage component(s). Remove the LH underhood apron from the vehicle.